|
| The recommended type of finishing for this type of ceiling is as follows: |
|
| The beading is finished smooth and fixed in such a manner that there is no gap left between the beading and the ceiling board or between the joint faces. |
|
| The beading is absolutely straight, parallel and plane. |
|
| The underside of the beading should be uniform. |
|
| The junction of the beading should be of fully mitred or of party mitred kind. |
|
| Where the joints are fully mitred, both the longitudinal as well as the cross beading shall be to the exact length as required by the panel arrangement. |
|
| Where the joints are of partly mitred variety, the length of the beading in one direction can run continuously over more than one panel. |
|
| The minimum lengths of the these beading should be 1.8 metre. |
|
| The joints shall come at a corner of a panel and not in the middle of the panel side. |
|